A high power laser measuring device based on radiation pressure is built. The mass measurement repeatability and the laser power measurement repeatability were experimentally studied. The experimental results show that the measurement repeatability of the radiation pressure measuring device gradually decreased with the increase of the measured mass and the measured laser power, indicating that the radiation pressure method has more advantages in measuring high power lasers. In the laser power measurement repeatability experiment, the influence of eccentric load and airflow disturbance is avoided, so the laser power measurement repeatability is better than the measurement repeatability calculated according to the equivalent mass.
UV radiometers are used in many areas. There are many kinds of UV light sources with different peak wavelength and different wavelength range. The broadband UV radiometers are wildly used due to easy to use and low cost. However, there are some obvious disadvantages for the broadband radiometers. They cannot distinguish the spectral characteristics of UV sources. That will cause the spectral mismatch measurement error for the UV broadband radiometers calibration. Recently, the fiber spectroradiometer plays a more and more important role in this area. The fiber spectroradiometer is more portable and low cost compared to the double grating spectroradiometer. We can obtain the spectral characteristics and any UV irradiance using the fiber spectroradiometer. However, for most fiber spectroradiometers, we cannot use them to replace the UV broadband radiometers for the absolute irradiance measurement. There are four key effects for that. The first one is the stray light. Stray light effect is obvious for the fiber spectroradiometer, especially in the UV wavelength range. The second one is the temperature effect. The third one is the non-linearity effect. The fourth one is the bandwidth effect. This effect will cause the measurement error for the spectral distribution of the UV source. In this paper, we research the four factors that reduce the measurement accuracy of the fiber spectroradiometer in UV wavelength range.
A new comparator facility for spectral responsivity calibration of InGaAs photodiode based on cryogenic radiometer fundamental has been set up at the National Institute of Metrology of China (NIM). The comparator employed a stable supercontinuum light source, a prime-grating monochromator, a reliable 5-axis stage and some necessary optics as its main construction components. The supercontinuum source, monochromator and some beam path were also commonly utilized by the cryogenic radiometer, which was designed to minimize the deviations to the calibration procedure introduced by these components. The spectral responsivity of the InGaAs photodiode in the spectral range 900nm- 1600nm was determined. The repeatability obtained by this new comparator is one decade better than that of former InGaAs measurement facility. NIM has been better supported to finish the measurements of transfer detectors of key comparison of CCPR-K2.a.2016 by this new and accuracy comparator.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.