12 March 2012 Atomic force microscope method for sidewall measurement through carbon nanotube probe deformation correction
Author Affiliations +
Abstract
To use atomic force microscope to measure narrow vertical features is challenging. Using carbon nanotube (CNT) probes is a possible remedy. However, even with its extremely high stiffness, van der Waals attractive force from steep sidewalls bends CNT probes. This probe deflection effect causes deformation (or "swelling") of the measured profile. When measuring 100-nm-high vertical sidewalls with a 27-nm-diameter and 265-nm-long CNT probe, the probe deflection at the bottom is estimated as large as 5.8 nm. This phenomenon is inevitable when using long and thin probes. We proposed a method to correct this probe deflection effect. Detecting torsional motion of the base cantilever of the CNT probe makes it possible to estimate the CNT probe deflection. Using this information, we have developed a technique for correcting the probe deformation effect from measured profiles. This technique, in combination with correction of the probe shape effect, enables vertical sidewall profile measurement with AFM.
© 2012 Society of Photo-Optical Instrumentation Engineers (SPIE) 0091-3286/2012/$25.00 © 2012 SPIE
Masahiro Watanabe, Shuichi Baba, Toshihiko Nakata, Takafumi Morimoto, Satoshi Sekino, and Hiroshi Itoh "Atomic force microscope method for sidewall measurement through carbon nanotube probe deformation correction," Journal of Micro/Nanolithography, MEMS, and MOEMS 11(1), 011009 (12 March 2012). https://doi.org/10.1117/1.JMM.11.1.011009
Published: 12 March 2012
Lens.org Logo
CITATIONS
Cited by 20 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Atomic force microscope

Carbon nanotubes

Atomic force microscopy

Silicon

Calibration

Cadmium

Eye

Back to Top