All-fiber micro-machined Fabry-Perot strain sensor

Simon Pevec; Denis Đonlagić

doi:10.1117/12.921845

25 April 2012 All-fiber micro-machined Fabry-Perot strain sensor

Simon Pevec, Denis Đonlagić

Proceedings Volume 8426, Microstructured and Specialty Optical Fibres; 84261D (2012) https://doi.org/10.1117/12.921845
Event: SPIE Photonics Europe, 2012, Brussels, Belgium

Abstract

This paper presents the design, fabrication process, and experimental evaluation of a high-sensitivity, all-silica, all-fiber, micro machined Fabry-Perot strain-sensor. This sensor has a short Fabry-Perot cavity and thus allows for the application of low-resolution spectral interrogation systems; in our case the commercial white light signal interrogator was used. The fabrication process includes the design and production of special sensor-forming optical-fiber. This fiber includes a central titanium-doped region, a phosphorus doped-ring surrounding a titanium doped region, and pure silica cladding in order to produce the proposed sensor, two sections of sensor forming fiber are cleaved and etched in a HF/IPA solution. The phosphorus-doped region etches at a considerably higher rate than the other fiber-sections, and thus creates a deep gutter on the cleaved fibers frontal surface. The titanium-doped region etches at a rate that is, to some extent, higher than the etching-rate of pure silica, and thus creates a slightly retracted surface relative to the pure silica fiber-cladding. The etched fibers are then re-spliced to create an all-silica strain sensor in "double configuration", which has a section of etched sensor-forming fiber on both sides. Thus this sensor has a long active length, whilst the length of the Fabry-Perot cavity can be adjusted by a titanium-doping level. The central titanium-doped region also creates a waveguide structure that is used to deliver light to the cavity through one of the fibers. The proposed fabrication process is cost-effective and suitable for high-volume production. The greatest achievement of the depicted in-line strain sensor is the extension of its active sensor length, which is more than 50 times greater than the sensor-cavity's length, and is thus approximately 50 times more sensitive to strain. This sensor also exhibits low-intrinsic temperature sensitivity.

Citation Download Citation

Simon Pevec and Denis Đonlagić "All-fiber micro-machined Fabry-Perot strain sensor", Proc. SPIE 8426, Microstructured and Specialty Optical Fibres, 84261D (25 April 2012); https://doi.org/10.1117/12.921845

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available