Paper
24 March 2006 Leakage monitoring and control with an advanced e-beam inspection system
Hermes Liu, J. H. Yeh, Chan Lon Yang, S. C. Lei, J. Y. Kao, Y. D. Yang, Mingsheng Tsai, S. F. Tzou, Wei-Yih Wu, Hong-Chi Wu, Hong Xiao, Jack Jau
Author Affiliations +
Abstract
Junction leakage control is studied with electron beam (e-beam) defect inspection after tungsten chemical mechanical polishing (WCMP). Leakage-induced bright voltage contrast (BVC) defects are detected. For both wafer to wafer (WtW) and within wafer (WiW), e-beam inspection results strongly correlate with leakage results of wafer acceptance test (WAT). Failure analysis results showed that the junction leakage was caused by lateral diffusion of nickel silicide (NiSi) underneath the spacer. The extrusion length correlates with gray levels of the tungsten plug very well. In this study we found the optimized condition to suppress junction leakage and also confirmed that post WCMP e-beam inspection can be used to monitor and control junction leakage.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hermes Liu, J. H. Yeh, Chan Lon Yang, S. C. Lei, J. Y. Kao, Y. D. Yang, Mingsheng Tsai, S. F. Tzou, Wei-Yih Wu, Hong-Chi Wu, Hong Xiao, and Jack Jau "Leakage monitoring and control with an advanced e-beam inspection system", Proc. SPIE 6152, Metrology, Inspection, and Process Control for Microlithography XX, 615249 (24 March 2006); https://doi.org/10.1117/12.656207
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Semiconducting wafers

Inspection

Scanning electron microscopy

Diffusion

Nickel

Defect detection

Tungsten

Back to Top