Paper
29 November 1979 Optical Design And Evaluation Of Large Aspherical-Surface Plastic Lenses
Ellis I. Betensky,, Brian H. Welham
Author Affiliations +
Abstract
Over the last several years there has been a growing consumer interest in Large Screen Television; large screen being defined as a 45 inch to 96 inch diagonal image. Present technology accomplishes this size imagery by using a lens to project a CRT image onto a viewing screen. Systems being manufactured today consist of front or rear screens, one or more CRT's and one or more lenses. The primary performance requirement most difficult to achieve economically is sufficient light output to permit comfortable viewing with a high ambient light level. This requirement, in conjunction with maintaining image quality, a reasonable configuration and low cost, established the need for inexpensive large aperture lenses. Several types of all-plastic objectives and large plastic Schmidt correctors are presently in production at U. S. Precision Lens to meet this growing requirement. The following discussion describes the optical design of the large refracting systems and some of the difficulties associated with these designs.
© (1979) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ellis I. Betensky, and Brian H. Welham "Optical Design And Evaluation Of Large Aspherical-Surface Plastic Lenses", Proc. SPIE 0193, Optical Systems in Engineering I, (29 November 1979); https://doi.org/10.1117/12.957875
Lens.org Logo
CITATIONS
Cited by 7 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Optical design

Optical systems engineering

CRTs

Manufacturing

Plastic lenses

Aspheric lenses

Lens design

RELATED CONTENT

Resolving Optical Design/Manufacturing Hang-Ups
Proceedings of SPIE (September 16 1980)
Invited paper Status and future of polymeric materials in...
Proceedings of SPIE (January 01 1991)
Optics cost modelling and design optimization
Proceedings of SPIE (May 14 2010)
Aspheric glass lens modeling and machining
Proceedings of SPIE (August 26 2005)
Automated optical assembly
Proceedings of SPIE (August 18 1995)
Basic considerations for injection molding of plastic optics
Proceedings of SPIE (December 01 1995)

Back to Top