|
In this paper, we demonstrate possibility of simultaneous achievement of high peak and high average power in picosecond pulses using a monolithic amplifier based on a long Yb-doped tapered fiber. Due to a very high pump absorption (~ 25 dB/m at 976 nm) in the realized 2.4 m long tapered fiber most of the pump is absorbed near the thick tapered fiber end and a very small fraction of pump power reaches thin fiber end. As a result, signal passes through the thin part of the tapered fiber without an amplification and exhibits fast growth only near the output tapered fiber end, where a mode field diameter is large (35 μm at 1064 nm for 46 μm output core diameter), so that pulses can be amplified to a high peak power. Moreover, only a negligible fraction of pump radiation leaks at the conic part of the tapered fiber, because its most part was absorbed in the thick tapered fiber part. Thus a safe operation without polymer burning at a leakage point is possible up to a very high pump power. The developed tapered fiber was used in a final amplification stage of the all-fiber pulsed laser system, which allowed us to amplify 8.3 ps pulses with repetition rate of 18.4 MHz and central wavelength of 1064 nm to 150 W of average power and 0.92 MW peak power. The average power level was limited only by available pump power (230 W): no signs of transverse mode instability effects were observed.
|
